|
So Easy to
Install....
Set of 2 Vehicle Card Pockets Includes:
-
2 Pocket Business Card Holders
-
2 Card Holder Bases
-
4 heavy duty 3M Adhesive Strips
-
2 "Business Card Take One" vinyl,
self-adhesive signs (signs not exactly as shown)
Product
Dimensions:
Metric Measurements
-
The dimensions of the base are
10.64 cm long x 6.35 cm high x 0.95 cm thick.
-
With the card holder on, the
dimensions are 11.43 cm long x 6.35 cm high x 5.08 cm thick.
Imperial Measurements
-
The dimensions of the base are
4-3/16 inches long by 2-1/2 inches high by 3/8 inch thick.
-
With the card holder on, the
dimensions are 4-1/2 inches long x 2-1/2 inches high x 2 inches thick.
How to Apply the Vehicle Card Pockets Base and Card Holder
-
Clean surface where Base will be
applied.
-
Take Base and center where it
will be applied. Check back of Base to determine top and bottom.
-
Remove backing from one side of
adhesive strip and place one on each raised platform on the back of Card
Holder Base.
-
Once securely on platform, remove
remaining backing to expose adhesive and apply to cleaned surface with
pressure until affixed on surface.
-
Slide Pocket Business Card Holder down on brackets
until it clicks into place.
-
Open lid and insert cards.
How to Apply Signs
-
Clean surface where sign will be
applied.
-
Center sign in area where it will
be applied.
-
Gradually remove backing strip to
expose adhesive, while applying pressure to sign to stick to surface.
** Use edge of Card holder Base to
eliminate air bubbles when affixing sign to surface.
Upgrading your vehicle and need to
transfer Vehicle Card Pockets? Easy!
If you need to
remove the full unit:
- Remove card
pocket from base.
- Twist either side of base up and down until adhesive strip loosens from vehicle surface.
- Lift base off surface.
- Any remaining adhesive can be "rolled" off by rubbing your finger over it a few times.
- If some adhesive remains, a drop of nail polish remover on a cotton ball and a quick
wipe with a damp cloth will remove any remaining adhesive without damage to
the vehicle finish.
|
.jpg "vehicle card pocket, front view, detached from wall mount platform")
.jpg "vehicle card pocket, side view, showing back brackets which attach to platform tabs. Note thick, quality acrylic construction")
.jpg "vehicle card pocket, 1 full set")
"...Can't wait to get this product...I am surprised I haven't
heard of it before! Just got lettering put on my car and the cardholder will
be a great addition!!!
Please send some business cards---I attend a lot of
networking groups and wouldn't mind passing out your card. :)"
Julie Hampton, Sweet Pea Studios
Gulf Breeze, FL
|
|